09-03-2016, 04:15 PM
I have to share this with you as it is so “typical” of Zebra support.
I accidentally chose the wrong interface type when setting up a Symbol Barcode Scanner today.
The PC recognises the scanner when it is connected but the laser no longer scans.
For those who don’t know, all features/programing is done via scanning some barcodes from the user manual.
Now you would think that a “factory reset” would be simple – yeh right…
Referring to all Zebra support information, to perform a factory reset, I must scan a particular barcode in the manual!
For those who are switched-on no further explanation needed.
Hoping someone with awesome brains out there can tell me how to “unbrick” this barcode scanner (Model LS-2208)…
I accidentally chose the wrong interface type when setting up a Symbol Barcode Scanner today.
The PC recognises the scanner when it is connected but the laser no longer scans.
For those who don’t know, all features/programing is done via scanning some barcodes from the user manual.
Now you would think that a “factory reset” would be simple – yeh right…
Referring to all Zebra support information, to perform a factory reset, I must scan a particular barcode in the manual!
For those who are switched-on no further explanation needed.
Hoping someone with awesome brains out there can tell me how to “unbrick” this barcode scanner (Model LS-2208)…